Heat Transfer Machines

Key Specifications/Special Features:

• Specifications:
• Raw material:
  • Rolling welded steel tube: 4.76 to 6.35 x 0.71
  • Low carbon steel wire: 1.4 to 1.6mm
  • Bracket: steel plate SPCC thickness 0.6 to 2.0
  • Base mounting plate: SPCC thickness 0.6 to 2.0
• Technical standards: can produce according to client's drawings or samples
• Performance:
  • Surface with electrophoresis coating to prevent the corrosion
  • Inner cleanness can meet the requirement of R134a and CFC cooling system
  • Can satisfy the cooling capability requirements
• Structures:
  • Flat type of wire on tube condenser used at the back
  • Bended or spiral type of wire on tube condenser used at the bottom
  • Wrapped type of tube embed on plate
  • Flat type of Louvre condenser used at the back
• R134a cooling system tube inside standard:
  • Residual moisture: ≤20mg/m²
  • Residual dusty: ≤30mg/m²
  • Residual mineral oil: ≤ 7mg/m²
  • Residual chlorine: ≤3mg/m²
  • Sealing density: ≥1.65mPa
• Specification of E-coating:
• Coating thickness:
  • Thickness of anodic electrophoresis coating: ≥12μm
  • Thickness of cathodic electrophoresis coating: ≥ 20μm
  • Hardness of coating: ≥2H
  • Impact of coating: 50kg/cm impact, no crack
  • Adhesion of coating: ≥2 grade
  • Flexibility of coating: around R=3D bend 180 degrees, no crack or no fall off
  • Corrosion-resistant (salt spray GB2423)
  • Anodic electrophoresis coating: 24 hours
  • Cathodic electrophoresis coating: ≥96 hours
  • Packing:
  • Standard export carton and wooden pallet

  Payment Details:

  Payment Terms:
  
  T/T, L/C AT SIGHT